Thanks:
0
Likes:
0
Dislikes:
0
-
saad jilani
- Rep Power
- 32
Ricoh 2090 download error e44
Hi,i have one machine ricoh 2090 this machine problam is caming e 44 how to reset this code.
-
From the Knowledge Base.......
[Symptom]
The "E32" and "E44" error codes are displayed.
When several softwares are installed in a same time, the "E32" and "E44" error codes may be displayed which will not turn off even if the SD card is removed and the power is turned off and on, and the system will not be ready for use.
[Cause]
A firmware transmission error may occur when installing several types of firmware simultaneously. Since the error data is saved to the NVRAM, the machine is unable to boot up normally, even after the main switch is turned Off/On.
SOLUTION:
Clear the error code with the following procedure and re-install the firmware again.
How to cancel the errors:
1) Press "143" using the number keys while the error code is displayed.
2) Press the "CLEAR" key 3 times.
3) The system will beep 3 times and the error display will disappear.
To ensure the above error codes do not occur, please be sure to follow the procedure below whenever installing several kinds of firmware at the same time:
1. First, install the ??System?? firmware only.
2. After successfully installing the ??System?? firmware, turn the machine main power Off/On and confirm that the machine boots up to Ready status normally.
3. Install the remaining firmware simultaneously.
Note: Refer RTB RB070040 as to details.
-
This Parts & Service manual can now be purchased for $11.77 and downloaded immediately after payment from The Internet's largest collection of manuals
Paul@justmanuals.com
-
$pam - just ask in the forum if you need a manual, usually someone is going to drop you a PM.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks