Hi.
I have Af MP 161 spf always pop up SC 542 and the fusing unit overheat.I already replaced thermsitor, thermostat and do reset the sc but still the problem.any idea on this issue.thanks.
tekcopyer
Hi.
I have Af MP 161 spf always pop up SC 542 and the fusing unit overheat.I already replaced thermsitor, thermostat and do reset the sc but still the problem.any idea on this issue.thanks.
tekcopyer
Everybody wants to go to heaven, but nobody wants to die.
First of all 542 is a warmup error, not overheat.
And it's usually the thermistors, thermostats, lamps, power supply or connections thereof.
Ricoh & Microsoft may pay the bills but Un*x saves my ass every day.
MCSE/CCNE/ENS and other crap...
Leave the front cover off that shields the fuser lamp connectors and see if the lamp even comes on. If not, check the lamp for continuity. If that's ok then if you have access to another fuser unit swap it for testing. If you still get the error then the problem is probably going to be the power supply (secondary would be the connection).
Its not sitting under an air conditioning duct is it? Can you reproduce the symptoms in the afternoon?
You never realize how cheap a professional is until after you let an amateur do it.
A+; Network +; PDI+
HI to all.
The pressure roller melt and stick to the hot roller. like the thermistor don't cut off, no sig nal to off the supply for fusing unit. my problem is i don't have extra power supply and main board to test.
thanks
tekcoper
Everybody wants to go to heaven, but nobody wants to die.
' "But the salesman said . . ." The salesman's an asshole!'
Mascan42
'You will always find some Eskimo ready to instruct the Congolese on how to cope with heat waves.'
Ibid
I'm just an ex-tech lurking around and spreading disinformation!
Looks like an AC Driver failure for me, remove the PSU and check the TRIAC on it, which will drive the fuser lamps. Meter it out and check for short circuit between A1 and A2. A new one will cost you only a few dollar on a radio shack.
If sometimes you feel a little useless, offended and depressed always remember that you were once the fastest and most victorious sperm of hundreds of millions!
Apparently it was a one-time situation. A colleague in the meantime placed a new fuser and it's working fine. If I understand correctly, if it was the failed Triac, it would happen right away with the new fuser, right?
There are no remains of unsupported transparencies or anything that might've caused that, so we've no idea.
' "But the salesman said . . ." The salesman's an asshole!'
Mascan42
'You will always find some Eskimo ready to instruct the Congolese on how to cope with heat waves.'
Ibid
I'm just an ex-tech lurking around and spreading disinformation!
update firmware man.
Bookmarks