A new nvram would be completely clear, so no, it wouldn't fix it.
A new nvram would be completely clear, so no, it wouldn't fix it.
' "But the salesman said . . ." The salesman's an asshole!'
Mascan42
'You will always find some Eskimo ready to instruct the Congolese on how to cope with heat waves.'
Ibid
I'm just an ex-tech lurking around and spreading disinformation!
That wont work, it would code out right away with a mismatched serial number.
You never realize how cheap a professional is until after you let an amateur do it.
A+; Network +; PDI+
Interesting!
So how whould you make it? It sounds so that you know the procedure?!
The hole controller board send to ricoh and they'll programm it new?
If so how will they do that. Is it possible to flash the ic via internet?
thanks a lot!
Ricoh doesn't repair boards anymore, at least on this side of the pond. If you can find an authorized repair center they can do it for you. i.e Hytec Board Repair in Florida.
You never realize how cheap a professional is until after you let an amateur do it.
A+; Network +; PDI+
So - of course it prints but ...
How was the registration of the four colors after the replacement? I thought all laser units comes with individual parameters from the manufacture which were written in the board.
Or did you have a backup from all these parameters and put in all the adjustments in the machine again?
If not it sounds for me that you are maybe lucky that it prints marvelous.
Thank you for further information!
Last edited by dgressy; 01-24-2012 at 11:32 PM.
Bookmarks