whats sc 555?
whats sc 555?
The book says:
Heating roller lamp consecutive full power 2
The heating roller-fusing lamp stays ON for 15 seconds or more while the fusing
unit is in the ready condition.
• Broken heating roller fusing lamp
1. Replace the heating roller fusing lamp.
2. Replace the PSU.
The lamp is damaged and i believe there is a firmware upgrade for this once the lamp is replaced. Somthing to do with how the lamp is being switched on has been changed with the new firmware update.
rtb 41While the machine is in the Standby (Ready) condition, the temperature of the tungsten
wire in the halogen lamp tends to weaken the wire. If the total time spent in the Ready
condition is long enough, eventually the wire breaks.
Upgrade the Engine firmware to
1.55:09 or later as soon as possible by @Remote
or at the next service visit.
The fusing lamp control was modified so that the temperature conditions do not weaken the tungsten wire.
Networking skills are advantageous but use of a 3m vacuum cleaner is essential
Like Leo34staffs said, upgrade the engine firmware and you'll never see this SC again.
Drop Sp1107 -1 & -3 to 195 degrees then increase -2 & -4 to 70 seconds. Also do the firmware. If you change Sp3904 I would also change Sp2804 to 0 (OFF) to avoid Sc305 codes.
hi
thank you gentleman but which lamp because ther are two one is 500/700 w the other is 250w
Sc555 has bitten everybody who works on these. I've tried the hardware & firmware fixes, but the Sp1107 fix I found on this site is what finally got rid of the problem. Unfortunately I can't find the posts I stol/aquired the attachments from.
This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals | The Internet's largest selection of manuals | Instant Downloads
Paul@justmanuals.com
Bookmarks