hi all,
Can anyone help with error code SC 818 on this machine?
Thank you.
hi all,
Can anyone help with error code SC 818 on this machine?
Thank you.
SC818 - Watchdog error
While the system program is
running, a bus hold or interrupt
program goes into an endless loop,
preventing any other programs from
executing.
Possible Cause
• System program defective; switch off/on,
or change the controller firmware if the
problem cannot be solved
• Controller board defective
• Controller option malfunction
-----------------------------------------------------------------------
I would recomment removing the controller and cleaning all of the contact points with Deoxit or a similar contact cleaner and update the firmware before considering replacement of the controller board.
This Parts & Service manual can be purchased for $12.77 and downloaded immediately after payment from
Just Manuals | The Internet's largest selection of manuals | Instant Downloads
Paul@justmanuals.com
First at all, rewrite all(!) Firmware, newest versions of course.
Second, exange RAM against known good one
If sometimes you feel a little useless, offended and depressed always remember that you were once the fastest and most victorious sperm of hundreds of millions!
Bookmarks