906 ex

[T911]

had a sc320 and replaced the dev power pack. now it won't feed from registration. tried to run reg motor in sp but no response. should i go for the motor or io. thanks t

[ucinn]

had a sc320 and replaced the dev power pack. now it won't feed from registration. tried to run reg motor in sp but no response. should i go for the motor or io. thanks t

While running the motor, check the voltage on both sides of the motor.. if you have the same voltage on both sides, it's the board, if not it's the motor.

[Jomama46]

Neither, until you run the motor is output mode and check the 24v on the IO.

[JustManuals]

This Parts & Service manual can be purchased for $12.77 and downloaded immediately after payment from

Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads

Paul@justmanuals.com

[T911]

While running the motor, check the voltage on both sides of the motor.. if you have the same voltage on both sides, it's the board, if not it's the motor.

it was the motor. thanks much