Thanks: 0
Likes: 0
Dislikes: 0
Hi all,hope you can help.
My 2510 has a dark shading on one trailing edge corner of A3 & A4 reduction,only when using platen glass not adf,the shading starts approx 4
inches from trail edge and gradually gets darker until it is like two bands 1 inch wide.
thanks in advance
Sounds like one of the carriages is not aligned. You woulndt see that in ADF mode. I would start by jigging the 1 and 2 carriages. Also make sure the mirrors are secure and not moving.
You never realize how cheap a professional is until after you let an amateur do it.
A+; Network +; PDI+
Thanks for the reply Jomama 46.
Tried the scanner,couldnt see anything,tried adjusting anyway and just blurred image with no effect on fault.
You cant adjust them without the jigsOriginally Posted by staffie man
You never realize how cheap a professional is until after you let an amateur do it.
A+; Network +; PDI+
You can, but it will just blur the image.
NEVER ASSUME ANYTHING
exactlyYou can, but it will just blur the image.
You never realize how cheap a professional is until after you let an amateur do it.
A+; Network +; PDI+
Maybe your Scanner Housing is bent. Grap the Housing at the front left corner, and give some moderate pressure from below, then make a Copy again. does something change?when using platen glass not adf
If sometimes you feel a little useless, offended and depressed always remember that you were once the fastest and most victorious sperm of hundreds of millions!
If fault is scanner/mirror alignment would there be two distinct bands, also image is visible below shading until it becomes too dark
Sorted. whole scanner carraige frame was twisted. Thanks for input
A timeless copier issue.
Reply With Quote
Bookmarks