I had posted about this last week thinking that the 3025 and MP2510 used the same print scan options.
Having been told they are different I now got the print scan dimm and sd card type 3010 but when I installed them in the 2510 they are not recognized, neither the buttons nor in user tools or SP mode.
Is there another step I need to complete the installation, it also has fax and document server and they are working fine.
You also got a hard drive with that also, didn't you (required)? This is from the manual (I've attached the complete section that gives you all the info you need) ...
20. Enable the network and USB functions.
Important: The NIB and USB functions must be enabled with SP5985. These
functions are built into the controller.
• To enable the Ethernet function, enter the SP mode and set SP5985-001 (On
Board NIC) to "1" (Enable).
• To enable the USB function, enter the SP mode and set SP5985-002 (On
Board USB) to “1" (Enable).
21. If there was no HDD in the machine before you installed the printer/scanner
unit or printer unit, do SP5846 41 to let the user get access to the address book.
Important
• This SP must be done immediately after installation of an HDD unit in a
machine that previously had no HDD.
• The first time the machine power is turned on with the new HDD installed, the
system automatically takes the address book from the NVRAM and writes it
on the new HDD. But, only the system administrator can get access to the
new address book on the HDD at this time.
• If you do SP5846 41 immediately after power on, then all users can use the
address book.
NOTE: It is not necessary to format the new hard disk after installation.
22. If there was no HDD in the machine before you installed the printer/scanner
unit or printer unit, do SP5853 to copy the preset stamp data to the hard disk.
Then turn the main power switch off/on.
Bookmarks