Thanks:
0
Likes:
0
Dislikes:
0
-
Senior Tech
100+ Posts
- Rep Power
- 28
MPC4000 LCT
When LCT attempts to move paper from left side to the feed side it will stop halfway across and then shutdown LCT. Have cleaned all sensors and checked belts, all look good. The LCT feeds paper from feed side with no problems until it starts to move left hand stack.
-
Re: MPC4000 LCT
check that the left side and right side tray are level - causes it to fault out with an error code when it trys to move over
-
Re: MPC4000 LCT
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.com
-
Re: MPC4000 LCT
Check with just a few sheets of paper in the tray. The driven gear on the shaft driving the left tray can round off and slip when the tray is full. there is a mod for the shaft and gear.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks