SC 101 (Aficio 551)

[fritzyas]

Vacuum static possibly Blown the Crap out of the little PCB in the Transfer unit and Blown the PCB at the same time.

X3..Sharpmind should pay for the defective board.

[josueol1]

In the case of SC 101 could be that the optic axis of this set with the spindle for fixing broken.
The exposure lamp is not illuminating enough and needs to be replaced.
or CCD this lens with reading problems.
In the case of SC 303 and charging unit esperimente swap the wires and the grid.

[sharpmind]

Still the problem is not solved. I already replaced the SBU unit and the board attached to it but still no luck. But I can get the print counter list. There is no jamming error now but stil SC 101 occurs,,,

[Dumus]

Clean optics!
What happens with a white stripe below the ruler, who holds the glass .

[Bantams]

Replace the Lamp Regulator PCB sits under the lamp on the electrical component layout diagram AZ50 0054 I Believe is the part number but its called a invertor in the parts manual best ring Ricoh and ask them first.................

[sharpmind]

Replace the Lamp Regulator PCB sits under the lamp on the electrical component layout diagram AZ50 0054 I Believe is the part number but its called a invertor in the parts manual best ring Ricoh and ask them first.................

I did but still same problem...

[sharpmind]

Clean optics!
What happens with a white stripe below the ruler, who holds the glass .

Already cleaned several times but still no hope ...

[sharpmind]

We are planning to pull-out the machine from the customer's place so that we can carefully check it in the service center. We have same old machine in our office and we will try to swap each parts to locate the problem. What a bloody machine..!