MPC 300 SC240

[Tuga]

HI

my machine MPC300 appears the code SC240 already tested the laser and the IPU board and continues to give the code SC240.
can help me thanks.

[Eric1968]

What do you mean by "testing the laser and the IPU-Board"?

The manual says that SC240 is an LD error K. Could be a bad LD-harness, a bad laser unit, or a bad BCU-Board.

[JustManuals]

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com

[Tuga]

What do you mean by "testing the laser and the IPU-Board"?

The manual says that SC240 is an LD error K. Could be a bad LD-harness, a bad laser unit, or a bad BCU-Board.

Hi
I tetsting in a new machine, the laser uni and the IPU Board

[sandmanmac]

Hi
I tetsting in a new machine, the laser uni and the IPU Board

Then I'd say it must be a BCU problem as Eric said

[gnr115]

ja tive um caso igual e tive de subs a unidade de laser

[rickg]

check the wire harness near the lvps. had couple of machines where the wire there were rubbing.

[CableGuy]

Maybe try another K PCU unit before you go ordering expensive boards, These things can kick out some odd messages sometimes and lead you up the garden path.....

[limo]

Do you fixed the m/c? what was the problem?I have the same situation.

[Tuga]

Do you fixed the m/c? what was the problem?I have the same situation.

HI
No do not solve the problem.But I look to test the BICU in another machine.