Hi Guys,
I went through the logs as discussed. There are quite a few "E" or ECMs on the log. I think we should disable ECM and adjust the baud rate as you mentioned.
Any clue how this can be accomplished?
Justin
Hi Guys,
I went through the logs as discussed. There are quite a few "E" or ECMs on the log. I think we should disable ECM and adjust the baud rate as you mentioned.
Any clue how this can be accomplished?
Justin
Look in the fax reference user manual, it'll tell you in there.
It's 106 miles to Chicago. We've got a full tank of gas, half a pack of cigarettes, it's dark and we're wearing sunglasses.
Hit it.
Under fax SP mode:
SP 1-104-002 Turn Bit 0 from 1 to 0 to turn off ECM.
Speed for starting transmission:
SP 1-105-006
Change/verify bits 3,2,1,0 are 0110 respectively. This is for 14.4 transmission. For 9600, should be 0100
SP 1-105-007
Change/verify bits 3,2,1,0 are 0110 respectively. This is for 14.4 reception. For 9600, should be 0100.
Klydon,
Thank you very much. Now I need to figure out how do put this unit into SP mode and we should be off to the races.
Forums,
How can I enable or disable ECM mode for this fax? Please advise.
Thank you,
JR
Bookmarks