MP 2352 Please wait message on screen

**3bok3bok68** · 08-23-2013

Originally Posted by Athlontini

If you call Ricoh they're likely to tell you to replace both the BCU and EEPROM, brand new, together as a set. If it was a brand new machine you cannibalized them from then I guess we'll rule them out.

Are you getting appropriate voltage from all connector pins on the power supply?

Yes! All voltage are okey. The cannibalized machine I already installed in the customer its work fine! I experience this problem many times only disconnect the HDD its work.

**rsyarcia** · 08-23-2013

Originally Posted by 3bok3bok68

"Please wait" message during installation MP2352, disconnect hdd still same. Replaced controller board, IPU, BCU and finally PSU same and not success. Thus anyone encounter this trouble? Please help. Thanksin advance...

you almost changed everything inside the new machine. maybe it's time to change the engineer("Please don't wait)

.just kidding. were you able to access the sp mode?

**slimslob** · 10-14-2013

If it has a FAX option installed, remove the FAX option. If that allows it to boot, replace both the GWFCU and the MBU.

**3bok3bok68** · 10-15-2013

Originally Posted by slimslob

If it has a FAX option installed, remove the FAX option. If that allows it to boot, replace both the GWFCU and the MBU.

There is no fax option installed in the machine slimslob...

**3bok3bok68** · 10-15-2013

Originally Posted by rsyarcia

you almost changed everything inside the new machine. maybe it's time to change the engineer("Please don't wait)

.just kidding. were you able to access the sp mode?

No rsyarcia I can't access sp mode...thanks...

**lupi** · 10-15-2013

Originally Posted by 3bok3bok68

"Please wait" message during installation MP2352, disconnect hdd still same. Replaced controller board, IPU, BCU and finally PSU same and not success. Thus anyone encounter this trouble? Please help. Thanksin advance...

Orlando suggest nial ay PM? palit machine na