Hi,
There are black background on Ricoh Aficio MP5000B copier. After servicing the machine
2 to 3 days its working fine & then its appearing again same problem. Please let me know
how to solve this problem.
With best regards.
Waliul
Hi,
There are black background on Ricoh Aficio MP5000B copier. After servicing the machine
2 to 3 days its working fine & then its appearing again same problem. Please let me know
how to solve this problem.
With best regards.
Waliul
The dev roller is probably fully coated black.
- Knowledge not shared, is eventually knowledge that becomes lost... like tears in the rain.
Fully qualified technician for Ricoh - Canon - Sharp - HP - Brother
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.com
Hi,
The development roller is not coated black. Even this is not over toning problem.
The problem is appearing after 2 to 3 days & then after servicing its working fine.
Please let me know the solution.
With best regards.
Waliul
Are you using OEM toner and the correct developer? B296 9640?
It's 106 miles to Chicago. We've got a full tank of gas, half a pack of cigarettes, it's dark and we're wearing sunglasses.
Hit it.
http://www.ricoh-support.com/tempfiles/RD009024a.pdf
"
2. Make the following SP mode changes:
- SP2201-01 (Development Bias): From 560 to 660
- SP2201-02 (Development Bias for ID sensor pattern): From 400 to 500 "
http://www.ricoh-support.com/tempfiles/RD009037.pdf
1. take off the toner bottle from the machine
2. print/copy while appears the "toner empty"
3. clean the developer roller, clean the waste toner unit, toner bottle unit.
4. change the sp modification
5. check the sp 2.001 (charge voltage) set the default 1.500 V !!!
upps...you cant oopen it
Define "servicing the machine", as in all service consumables replaced, or a "open,vaccum out and clean" service ?
Are these not the changes that were suggested, before they decided to modify the developer roller to a new coating version ? Is it the old version dev roller or the modfied one in the 'B' ?Make the following SP mode changes:
- SP2201-01 (Development Bias): From 560 to 660
- SP2201-02 (Development Bias for ID sensor pattern): From 400 to 500 "
Bookmarks