mpc 4500 sp5807 access

[Elmo]

i have a ricoh mpc 4500 with japanese language (in service mode only ) i know how to change it in area selection sp 5807 i have printed sp data log out on another machine and it shows up in the log , but when i go to it on this and other machines it does not show in service mode , it jumps from 5804 to 5810 even in special sm , does any one have a clue how to change this option , im sure i have done this in some older models

any help is much appreciated

thanks

as suggested by a nice tech on here i have been into factory service mode and set the area selection to eu but service mode still remains in japanese any suggestions welcome

[JustManuals]

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads



Paul@justmanuals.com

[ptrflrs]

i have a ricoh mpc 4500 with japanese language (in service mode only ) i know how to change it in area selection sp 5807 i have printed sp data log out on another machine and it shows up in the log , but when i go to it on this and other machines it does not show in service mode , it jumps from 5804 to 5810 even in special sm , does any one have a clue how to change this option , im sure i have done this in some older models

any help is much appreciated

thanks

as suggested by a nice tech on here i have been into factory service mode and set the area selection to eu but service mode still remains in japanese any suggestions welcome

Have you tried entering special service mode? //107 stop/hold down[*] on the control panel then press [copy sp] on the screen, et voila

[jonhiker]

i've seen this before, this fixed the problem>

from Gooses Guide:

SP modes ONLY in Japanese - IOB dip switches set wrong, #6=ON, #7&#8 = OFF

[Elmo]

cant find any dips on the iob if u mean controll board that slides in and out i have set the dips on there to your suggestion but no change , ive also pulled another 4500 board out and set them to the same as this and still no change

i would push it into a corner and try and forget about it but its quite a low meter reading so the boss will want it working grrr lol

[Elmo]

just tried it again switches are 1 on 6 on the rest set to off thankyou very much jonhiker you are a star