SC 995-01 MP5002

[katash]

HELLO TO ALL!

i replaced a controller board after the icons for the print/scan dissappered,put back the old nvrams in vain,went a step further and replaced the bcu and iob boards,I'm confused as the manual says its a bcu/nvram issue,please help i will really appreciate

SC 995-01

• Defective BCU
  
  
• NVRAM Replacement error
  

1. Install the previous NVRAM.
   
2. Input the serial number with SP5811-003, and turn the main power switch off/on.

[johnyb]

995 is a serial mismatch error, there are three areas where the serial is stored on this device and you need to check all three match up.
I think you may habe to go into special sp to input.
The novita one, as far as I am aware cant be adjusted.
Good luck.

[katash]

995 is a serial mismatch error, there are three areas where the serial is stored on this device and you need to check all three match up.
I think you may habe to go into special sp to input.
The novita one, as far as I am aware cant be adjusted.
Good luck.

thanks johny,

i have inputed the serial how do u get to ssp as the manual has a level 3

5811	MachineSerial
002	Display	Displays the machine serial number.
003	BCU	Inputs the serial number.
005	FRAM	Displays the FRAM serial number.

[katash]

any more ideas

[ptrflrs]

access special sp mode by holding down [#] key then hit Copy sp on the screen. does it have postscript sd card? try it with it out.

[johnyb]

pm sent

[katash]

access special sp mode by holding down [#] key then hit Copy sp on the screen. does it have postscript sd card? try it with it out.

thanks for the input,but still cannot access SP 5811-5 FRAM to check the serial no. is this the novita?

[ptrflrs]

thanks for the input,but still cannot access SP 5811-5 FRAM to check the serial no. is this the novita?

u mean nvram? FRAM might be "fixed ram" but not sure.

[katash]

u mean nvram? FRAM might be "fixed ram" but not sure.

me too not sure i've even replaced the nvram from another new mcn and input serial no. but to no avail,in a dilemma!

[katash]

DONE!!!

just realised you have to replace both eeprom and nvram at the same time and input serial no.