i have 2 machines have same thread when i do scanner adjustment it's failed .any suggestions. it's working but some times sc124 revealed and solved but when i go to sp mode to make scanner adjustment it's failed
i have 2 machines have same thread when i do scanner adjustment it's failed .any suggestions. it's working but some times sc124 revealed and solved but when i go to sp mode to make scanner adjustment it's failed
This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from:
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.com
From the Service Manual :
-Possible cause-
·
Scanner motor connector defective
·
Scanner motor defective
·
MCU defective
·
Scanner wire, timing belt, pulley out of position
·
PSU defective
BTW, this machine belongs to the museum....
We've had trouble with the scanner pulleys on these. the set screws loosen up and even break.
Let me guess : PSU
This is your last choice after all.
I think this one requires the scanner alignment pins. They go in from the top frame to alignment the carriages in the right position. Usually the pulley screws break off the front cable pulley or the back. Then it gets all skewed and maybe the cables pop off. The pins make it slot easier.
Bookmarks