Start key never turns green after warmup.......hit clear modes 107 clear stop to bring up service mode screen which displays copy sp and printer sp but when you select either one instead of entering the sp mode it waits about 30 seconds and then beeps and displays the sp screen again. So cannot enter service mode at all. Copier boots up normally when you power it on but since copy key never turns green it cannot be used. When you hit the printer button to the left it is stuck on loading. If you hit system status from the main copy screen the Hdd says memory available. 0 percent. sounds like a bad hard drive to me but thought I'd post here too see if there were any ideas. Comments appreciated.
Bookmarks