MP C305SPF MESSAGE : Cartridges are not set correctly (Black only)

[Polo-022]

To be continued....
Maybe this is for a new thread but i already mentioned that all this trouble started with a faulty 'replace toner cartridge' message!!! (There was still enough toner in the cartridge.)
After that, toner denity is pretty low in ALL (!) colors and i cannot recover machine!!!!
Initialization, New PCDU program from SP's,forced toner, entrance of Non Default Data didn't give me a sense that machine will be back on the pits. A software crash maybe, drove it there..
Any help will be much appreciated..

[Polarbear]

Hi there!
Had 2 of these machines with "toner not set"-message out of box. 2times there was the board, which causes the problem. Looking at the photo you can see a bent contact.
Greetings...

My problems were caused by the recepticles that contact the pdcu bias bushes. There are two silver contact on the left and right side of each area where the bush fits into, and a small cir ular silver contact in the middle. The ones on the sides were bent open. Are the ones in your photo of the toner bottle chip contacts?

Sent from my GT-P7500 using Tapatalk

[copier tech]

I have this same issue, "Black Toner IS Not Set" I can see one pin is bent on this board, I have bent it back but want to replace the board to be sure.
Could someone please supply the part number? I cant seem to find it in the parts manual!?

a20131202_112258.jpg

[Zeldaman]

Hi there!
BRB-board D1175162.
Greetings...

[copier tech]

Hi there!
BRB-board D1175162.
Greetings...

Awesome thanks

[copier tech]

Facing the same issue but with an MPC307, it appears the design is the same as the 305!?

[slimslob]

Facing the same issue but with an MPC307, it appears the design is the same as the 305!?

Hey grave robber, start a new thread.

[copier tech]

Hey grave robber, start a new thread.

Na dig up an old one!

[Dan G]

Facing the same issue but with an MPC307, it appears the design is the same as the 305!?

this is a result of toner mess in side. requires a massive cleaning to prevent toner bottle shutter stoppers from sticking and preventing bottles from fully inserting and not contacting RFID

[copier tech]

this is a result of toner mess in side. requires a massive cleaning to prevent toner bottle shutter stoppers from sticking and preventing bottles from fully inserting and not contacting RFID

Great PDF simple to the point.

I blasted the BRB pcb with air & fitted a new black toner bottle started working ok.

If issue returns will fit new brb & hopper.