907 smudge.pdf
Had new transfer unit and drum
907 smudge.pdf
Had new transfer unit and drum
My guess would be either a dirty laser shield glass or a dirty doctor blade.
well when I thought about it, I disagree slimslob. The counter page by default prints from tray 1 long edge feed. So since the drum and transfer were replaced, I would consider some issue with drum drive or transfer drive. Either way I would inspect what has been replaced, since there is no comment stating this happened after service or was going on before service. And is the blur on lead edge or trail edge?????? My $0.02 worth.....
Mystic Crystal Revelations
There is a clip on entrance guide on the transfer belt assembly, these often get worn and can get a sharp edge on that the lead edge of the paper hits causing the paper to stall. Check this. worth a shot.
¿Se haces la prueba en un A3 se repite el fallo?
¿Ocurre solo en la primera hoja?
####=========================####
Did the test beams in A3 the error occurs?
Does it happen only on the first page?
Antes de trocar alguma peça, eu esperimentaria polir o cilindro com Estearato de zinco..
Recebo algumas maquinas que a copia sai com esse defeito, geralmente é humidade.
Alguem pode traduzir!!
i would also guess on the drum drive its either the belt drive is worn out or a toner cake on the drive gear or the drive of transfer gear a teeth possibly broken. best of Luck Sir.
fix the customer first then fix the machine... its simple and makes life more easy.
seen something very similar to that a couple times, where toner on the drum drive gears caused it to mess up the image like that. we cleaned up the gears and the problem went away.
Last edited by freginold; 07-23-2014 at 07:19 PM.
-----------------------------------------------
Config page instructions for copiers, printers, & fax machines
Bookmarks