Anyone know how to turn off error message when you take a ps option out of one mpc3001 and put it in another?
Thanks
Kelly
Anyone know how to turn off error message when you take a ps option out of one mpc3001 and put it in another?
Thanks
Kelly
What error message?
Says this ps chip was already installed on another machine
Remove the PS SC card.
Not sure, but I think it has to be properly uninstalled from the original machine. Not just "yanked".
if I recall, the host MFP writes it's serial number to the card. No way to remove it, AFAIK.
“I think you should treat good friends like a fine wine. That’s why I keep mine locked up in the basement.” - Tim Hawkins
The PostScript SD option for the MP C3001 is a Type 5501. If it is any other type, you have the wrong SD card. If it were a MP C3002, I would be inclined to say that the application had been moved to another card using SP5873 and had not been moved back. The other possibility is that someone has attempted to access the card with a PC.
So we must "uninstall" the software back to the ps card before removing it? It is mpc3001
If it was moved. Moving places the application on the other card. Only an identifier is left on the original which allows the card to be identified when moving the application back. An SD card application can be used only on one machine at a time. Software copywrite protection laws.
The card only was moved and we only need it on one unit. Must it be uninstalled via service mode before removing from original machine before removing it and putting it in other unit?
Bookmarks