any one had this error tran unit seems ok hate these small boxes
any one had this error tran unit seems ok hate these small boxes
Do have the same problem,see that rtb change transfer belt to roller..
Change transfer roller but did not fix error code,machine start up sounds not normal so im checking to go that way...
So hope anyone had a fix on them..
Dont like the mpc305
Restart the machine & hold the main right door firmly shut does this help?
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
' "But the salesman said . . ." The salesman's an asshole!'
Mascan42
'You will always find some Eskimo ready to instruct the Congolese on how to cope with heat waves.'
Ibid
I'm just an ex-tech lurking around and spreading disinformation!
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Just for completion...
SC452
------------------------------------------------------
[Symptom]
Intermittend SC452 allmost overnight
------------------------------------------------------
[Cause]
Sensor below the Transferroller is not OK
Second possibility: the Door close mechanism is not really close
------------------------------------------------------
[Action]
Change the sensor or change the Hook's for the Close - Door mechanism
Do not change the Transfer Position Motor how it is written in Service Manual. This takes minimum 2h with no solution
Had a machine with sc452 due to damaged side cover.
Now rebuilt with new side cover.
No sc452 anymore but pale cq at paper transfer.
PTR bells out to earth so thing bias terminals all good.
Anyone had issues with PTR unit
Damn machine, I think the worst that RICOH has built in the digital age. I changed the closing of the doors, the sensors and a partner changed the transfer engine without success.
It has served to bend the metal sheet that acts on the sensor of the transfer roller.
1.- Remove the transfer roller.
2.- Fold / Replace the metal sheet where the sensor is placed, upwards.
Can you try telling me what happened? I apologize for my english
Bookmarks