Ricoh Pro c720

[jc1print]

try to check Sir PSU EA2 - FU3 (facing back side remove the lower right cover the board in the middle) and PSU G - FU2 (facing the back side the board at right underneath of AC Driver Board you can see this boards after you swing the lower right window) both 4A but be more extra carefull when removing this board bracket some connector dont have slack.

but still its a best to have a trained ricoh engineer look it for you Sir, Good Luck
but still it

power supply was bad really appreciate it now its just slow booting up hopefully i can get tech to come and tune it up!!!

[Imprestik]

Going off your picture there bud, do you have any finishing options or a large capacity tray?

If you do, the image you posted is only showing a base device.

I hope your under a service agreement because its going to get very expensive for you.....