Aficio 240w problem

[bat]

Hi all...

The machine is showing a ID sensor pattern on almost each print, even when Toner Supply Mode is set to Fix.

Thanks

image.pdf

[ranachinna]

Hi all...

The machine is showing a ID sensor pattern on almost each print, even when Toner Supply Mode is set to Fix.

Thanks

image.pdf

You check all sensors if you face again swap and check it

[tjvincent]

What have you done so far ?
Did you try replacing the cleaning blade ?

[ranachinna]

What have you done so far ?
Did you try replacing the cleaning blade ?

Are you check clean blade section

[slimslob]

Please attach a sample of the marks that you are talking about as the machine does not normally do a pattern every copy. My guess is that you have a bad drum.

[Polarbear]

You check all sensors if you face again swap and check it

Was the machine moved recently? There is a cleaning blade "park" lever below the drum (right hand side) of the frame.

If it was not set in the correct direction, the cleaning blade does not touch the drum and you will get repeat prints (ghosting).

[PA3040]

Clean the drum properly with water

[rsyarcia]

Push the cleaning blade release lever to the right. encountered this issue lot of times.