Does any one have experience interchanging controller unit (CTL) of MP5000 and MP4000?
I changed MP5000 CTL to MP4000 then SC995 rappers which is mismatch of controller
Should any one have solution for this error?
Does any one have experience interchanging controller unit (CTL) of MP5000 and MP4000?
I changed MP5000 CTL to MP4000 then SC995 rappers which is mismatch of controller
Should any one have solution for this error?
Hi there!
No chance, the controller are different, also other controller for the "B"-models etc...
Greetings...
I'm not sure... But check if there are dip switches on the controller.....
Memento Audere Semper
I remember the Aficio 3025...to fit the Aficio 3030 controller you had to set one bit switch to "on", because of the different speed..... I'm not sure if this works on a Mp4000...you should check the switches in both machines
Memento Audere Semper
I believe that one of the chip soldered to the board is a Programmable Logic Array that is programmed for the required model.
The MP 5000 has embedded scan/print. The 5000b is just a copier. There is a scan/print option for the 5000b that requires a scan/print sd card hdd and memory dimm iirc. also the 5000 can scan in color the 5000b scan/print option only does b/w scanning.
Bookmarks