hi
i just went to a mpc2800 i placed 2 weeks ago where the touch screen is dead,or black.
GOOSE GUIDE SHOWS
display goes black - update scanner fw to 1.24 or higher & system fw to 1.24 or higher No display - check for input voltage, replace PSU as needed no display - cracked soldering on polygon mirror motor pcb no display - update LCDC fe to 1.09 or higher
swapped the control panel out with my shop machine wth all updated firmware after cking bypass area for pinched wire.
no change. cked poly motor.ok
i cked all fuses on power supply and cked connectors but still the same.
does a mpc3300 power supply work in the mpc2800?
any other things that one would check?
the control panel leds seem to work and after 50 seconds it switched to printer and some alert led on.
thnx in advance
Bookmarks