Thanks:
0
Likes:
0
Dislikes:
0
-
Senior Tech
100+ Posts
- Rep Power
- 34
Aficio 700 sc441 come out
What the probebly problem if the A700 appear SC441.I ve notice the toner harden at lower mag roller,but why.
if A650 the clearence between the DV tank and Drum Can be adjusted but this model are fix.so what should I do?
-
Old Retired IKON Drudge
- Rep Power
- 33
The mechanical components of this print engine are based on the ancient analog FT5590 family. These machines would go into development motor lock when the development units were badly worn and/or the drive gears were badly worn. These machines also will lock up if one is using non-Ricoh developer and/or toner as they will overfill the unit. First thing I would do is clean out the unit. Vacuum out all the old developer you can; this will take much time as it is necessary to get out all you possibly can. Clean the magnetic rollers with Scotchbrite or similar non-metallic abrasive pad. With the unit empty, check it for binds. If it does not turn freely, I would suggest replacing the unit. You can get bearings and seals, but we never found it cost effective to rebuild as the units are jig assembled at the factory and one cannot get them perfect in the field. If the unit if free, install new Ricoh developer, going through all the steps in the manual. If the SC441 still occurs, it is time to replace the drive train to the development section. Not a fun prospect.
Doc
-
I think you have to check magn. roller o-ring bearings,then the idler gear between mag. and paddle roller. They use to stuck.
Otherwise fit a new bearing on developer drive motor assy.
Magnetic roll bearings can cause that feeling of hardened developer. Take a look!!
-
unTrusted Tech
250+ Posts
- Rep Power
- 36
verify the toner and developer if its genuine ricoh... then clean the dev unit, check the bearings lubricate it... if faulty.... then replace.......
-
Check your Developer drive motor , that is the most common thing to cause that code , there is a bushing in it that wears out.
-
Senior Tech
100+ Posts
- Rep Power
- 34
-
Field Supervisor
500+ Posts
- Rep Power
- 41
If the machine is building up excessive amounts of heat (enough to melt toner on the dv roller, make sure your exhaust fan filters are not clogged up.
-
Senior Tech
100+ Posts
- Rep Power
- 34
If I print just in 150 cps after warm up then the sc441 appear.its not a long time to build a heat around the drum.
I mean after I have service and clean up the tank and drum.an on the machine.Runs in 150 copies.
May be an alien there.ha ha ha ......................
-
Technician
- Rep Power
- 0
clean the devolper & drum motor
-
Senior Tech
100+ Posts
- Rep Power
- 34
thanks for your reply.actually the situation is this.
the toner harden at dv unit on mg roller.the motor nothing wrong.
I wonder why the toner become hardened there?
how ever Ive change the dv tank unit and its ok now
there are many possibality in this world its not wrong if we give any suggestion to the comunity
thanks man
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks