Hello, In A Ricoh PRO 906 I C495. I Replaced almost everything. Tonerbank
up to the developer unit. But after every 100 prints back into code. I did several times 2207-2. The tubes are clean.
Anyone have another solution?
Patrick
Hello, In A Ricoh PRO 906 I C495. I Replaced almost everything. Tonerbank
up to the developer unit. But after every 100 prints back into code. I did several times 2207-2. The tubes are clean.
Anyone have another solution?
Patrick
Have you replaced the toner supply clutch that drives the transport coil to move toner from the toner supply bank to the toner cylinder. Another problem can be the tube from the cylinder to the toner pump. These are manufactured with a white Teflon on the inside. Pinching the tube or cleaning it by running something through it can damage the coating. If the coating is damaged, the tube can clog quickly. I also had a problem one time with the motor that drives the toner hopper. NO SC but continual under toning. Toner was making it to the hopper but not coming out of it to the developer.
Are you getting toner to the developer unit? if not them you need to do as slimslob advised you to do in his post. and change the toner tube and maybe the toner hopper motor.
Totoro
Bookmarks