ricoh c430dn/c440dn question

[fshead]

hi
i am about to pick up about 10 units of used c430dn/c440dn to gut half of them for parts for mpc300/c400/c401
Never sold nor service these units.
CAn i get the true pm parts count via control panel?and is that count changed by the part being changed or is it done by tech via service mode like the
mp6001 series copiers.
I have the manual but did not see how to enter service mode.
thanks

[slimslob]

If it is a print only, it is a matter of holding down a couple of front panel buttons while powering on. You'll need to check a couple of older service manuals.

[fshead]

as far as i have seen these are print only units.

[keithxxiii]

Power On while pressing up and down buttons simultaneously, after around 10 sec, press the ok/# button.

[fshead]

Power On while pressing up and down buttons simultaneously, after around 10 sec, press the ok/# button.

i had tried that and couldnt get in service mode and ended up pressing the suspend and escape buttons and then power on.