Swapped fuser on this little jem of engineering, ng. power supply maybe??
Swapped fuser on this little jem of engineering, ng. power supply maybe??
Did you go into service mode and clear the error after you swapped the fuser unit?
Yep did that, failed...
If you're installing a "Donor" fuser, check the thermistors. I've seen some throw SC 5XX codes just because they were caked with old toner. Clean them, reset the code again, and give it a test.
Brand new out of the box, lamps good, book says try power supply
do you have a working 2nd machine to test the "brand new one"?
did you meter the lamps and such?
Did you connected the small connectros on the right side at the back, near the power plug?
Did you enter the SP to move the gear of the pression roller to the position to attach the fuser?
Check this.
Enviado desde mi Redmi 4X mediante Tapatalk
Bookmarks