When starting up the machine I have been getting this message. If I power of and on it goes away. Does anyone know what causes this and how can I fix it.
Thanks
Bob g
When starting up the machine I have been getting this message. If I power of and on it goes away. Does anyone know what causes this and how can I fix it.
Thanks
Bob g
Transfer belt issue. Clean the ID sensor located to the left of the transfer belt. If that fails, take the transfer belt off, clean the silver roller at the upper left, if that fails replace the belt or entire unit. My moneys on the id sensors being dirty/silver roller being crusted.
VectorLinux---Check it out!
Also, drums that have reached their life or beyond can cause faint chevrons used for color registration which in turn gives you the 285. First check: Pm counters for drums/dev units. Then check for worn out charge rollers in if the drums are still within pm limits.
VectorLinux---Check it out!
SC 285 Line position
adjustment
(MUSIC) error
Line position adjustment fails
three consecutive times.
causse
• Pattern sampling
error due to
insufficient image
density of patterns
used for the
adjustment
• Inconsistency in the
sampling line position
adjustment pattern
due to dust on the
pattern, damage to
the OPC drum,
damage or toner
dropped on the
transfer belt, or a dirty
or defective ID sensor
1. Turn the main switch off and on.
2. Check and fix the problem that
causes low image density. .
3. Clean or replace the transfer belt
and/or the ID sensor.
4. Replace the PCU or clean the
development unit that causes toner to
drop on the transfer belt.
this said but I don`t know.
Cleaning the ID sensors and the upper left roller is good but the AP3800 doesn't use this roller for reflecting the id sensor beam like the newer models.
The AP3800 is old so I guess the transfer belt is wasted or maybe damaged by not correctly inserting one of it's units.
It's also necessary that the machine is technically able to reproduce an adequate image density (for the ACC patterns).
replace transfer unit, i believe the part number go773802 dont quote me on the part number.
If one of the colors is to light, cause of no toner or developunit damage, the color registration don't work.
If the registration failes and the marge is to high the machine can't set its self automatically.
In SP mode You can do settings for main adjustment after that the machine is able to do the fine adjustments.
gr ben
Bookmarks