Ricoh 2045esp pcr setting is changing

[Rick]

After installing new drum blade and pcr I set the ID sensor and initialized the developer. The pcr voltage went to 1500 but the copy showed marks in the middle of the page. When I adjusted the pcr voltage manually to 1650 the copy is fine . Later I was informed that there were marks again on the copy and I discovered that the pcr voltage readjusted itself to 1500 . Is there a way to keep the pcr set at 1650.

[Scott_Lewis]

After installing new drum blade and pcr I set the ID sensor and initialized the developer. The pcr voltage went to 1500 but the copy showed marks in the middle of the page. When I adjusted the pcr voltage manually to 1650 the copy is fine . Later I was informed that there were marks again on the copy and I discovered that the pcr voltage readjusted itself to 1500 . Is there a way to keep the pcr set at 1650.

Although I'm NOT recommending it, I think what you need to change is SP2005. Specifically 2005-3.

The longer I work on these, the less I mess with the process settings.