Thanks:
0
Dislikes:
0
-
Trusted Tech
50+ Posts
- Rep Power
- 22
CL7200 fails color registration
Hi All
I'm working on a CL7200 that the customer replaced the fuser that made the color reg. go out of adjustment. We had another tech go out to work on the printer a replaced the ID sensor but didn't fix the problem. I went out to get another set of eyes on it and cleaned the transfer belt roller under the ID sensor,
No change.
Any help would be appreciated.
Thank you in advanced
PS here is a test pageS35C-115030913030.pdf
-
Re: CL7200 fails color registration
These printers, and the copier versions, were always losing their registration. Make sure the transfer belt isn't slipping or pulling as well, and also see if printing on ledger or A3 paper makes any difference in the alignment, which will help you to rule out an issue with the belt.
Other than that, prepare to while away the hours making adjustments in SP mode.
-
Trusted Tech
50+ Posts
- Rep Power
- 22
Re: CL7200 fails color registration
When I ran the test pattern on 11 x 17 it does the same thing. I was wondering what adjustments are going to be the best to adjust to fix the problem.
Thank you again
-
Re: CL7200 fails color registration
When doing a color registration always clean the ID sensor assembly first. If after cleaning the ID sensor the registration still keeps going out, replace the ITB assembly.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks