Samsung SL-C460 resets

[akmodan]

I still have 10% of toner. I think its not fair to exchange a toner I have not used like Yellow since I have Used only Black. I dont understand why the toner count even when its not used.

Is it possible to reset it or change the configuration to use the toner longer until the end? Thanks!

[1stcavvet]

no you can't reset , the color toner uses a little to calibrate and initialize every time its turned on that's how it eventually gets depleated

[eliaso]

hello, I did not found how to go to thech mode

[eliaso]

I found the solution
it need to change the resistance 56 ohm on the drum unit

[tony10x]

Does this same direction apply to my Samsung c460fw printer .. I too have installed a new belt and my printer says prepare new belt and replace fuser soon.

I went thru the reset sequence but was unable to find or access tech mode ??

Thanks

[eliaso]

Does this same direction apply to my Samsung c460fw printer .. I too have installed a new belt and my printer says prepare new belt and replace fuser soon.

I went thru the reset sequence but was unable to find or access tech mode ??

Thanks

menu # 1934 menu

[eliaso]

https://youtu.be/_DCHhm7c_ZM
but it still need a pass code to reset, if you find samething tell please

[cleobuline]

Sequence is correct, but You need enter it not too slow and not too fast Try again and good luck!

i tried more than 20 time . on my C460 serie printerr , but it does not worh , please help

[geltrons]

how to reset samsung c430 drum