Search:

One I have seen is when a PM is done (replacing both PCU and DV tanks) the bushing and circlip has been left off (bushing and circlip are on the rear of the PCU and DV assy and hold the units...

Just uploading the Scanner Manual now for you:


http://ricohmanuals.com/manuals/AF1224C-1232C/pr1232_scanner.pdf

:)

Hi All,

I am in need of Xerox DC1250 Drum Cart, fusing rollers and toners.

If anyone can supply, please let me know. Would prefer OZ or NZ contacts.

Cheers

Yup, that's why I needed do disable the EFI SW so that I could install the drivers for the new network card.



The KB/M don't work now because I had to re-enable the EFI software.

Sorry guys - they were both X12's - must have had XP on the brain when I posted.

Hi all,

thought I would share a solution that I 'hacked'.

One of my X12's stopped working and I stripped it right down and had some serious words with it. After replacing the 8gb hdd with an...

Hi All...

fixed! I thought i'd get down and dirty with the retract clutch... While getting in there, i noticed a connector was dislodged... Plugged it in and het presto! Working!... Am picking...

you mean fanning of the paper? Try adjusting the pressure in the fuser and also check the state of the picker fingers.

I've had a lot of experience with Ricoh Priport over the years, but have to agree with the above posts, now that the cpc is reasonable, there is not much need for ink.

Sure, the HQ versions of...

yup, definatley a bend! I'll have a go at un-bending it and report back! thanks

cheers guys...

i'll give those suggestions a go tomorrow. I'm a Ricoh tech, and first time playing on Xerox, long time looking! (long story, maybe offline some time!):)

Techmate... damaged...

Hi,

my freight company dropped my MPC3260 off... a forklift.... !

Trying to get to the bottom of it's issues, and I come up with SC348, which I am guessing is drum related?

Anyone know what...

Hi all,

I have just had a DC1250 delivered (was working in NZ) to me in Vanuatu with the error 9-345.

I have cleaned the toner from the drum edge and checked the transfer belt as advised from...