Search:

I don't think is p/n for just frame it comes as an assembly. I might have one if need just frame, need screws also ?

I've tried them also never worked for us glad have better luck up till this one anyway.

I have one new in box if still looking for one. craig@akcopy.net

I may have one, you can't get yours fixed at Hytec ? I'll look tomorrow and let you know.

I'm assuming wasn't OEM toner, I have never had great copy quality with any of my Kyocera's unless use OEM no matter what any of the toner salesmen tell me. My boss has made me use it occasionally to...

I have all the firmware for this machine and looked thru it I can not find the one you mention in your post, where did you get that number ?

So you need this firmware ? I have it if you want it.

I looked at book and went to a machine it says resetting to factory default for U002 it may not reset code but it does say for reset to factory default. U021 may also work though.
U002 Setting the...

Can try U002 in service mode that sets back to factory defaults, hopefully that would put the password back to admin00.

Unless someone has one laying around you can't just buy the lamp anymore. The whole upper half of fuser is only like $50 from Kyocera.(P/N 302C993352 ) If I had old one would send it to you, we just...

I'm SURE I HAVE ONE BEEN PARTING OUT SOME FALCON III'S. LOOKING FOR WHOLE UNIT P/N 302GR93160 ?

Thank you very much for the help, customer was very happy to find that out.

One thing to check also is the little board that the cis cable plugs into. I've had a few come loose causing a code, had happen on new install years ago when they first came out. Just take cover off...

Can a Ricoh 906EX do some form of compression when scanning to make file sizes smaller when doing big jobs ? or can the MPC4000 do any kind of compression ? Customer asked today I know I can on my...

Yes the photo interrupter on bottom. One arm goes thru when originals are put in the df tray.

I don't remember there being any different print boards between the Falcon 1's. If works in a 40 should work in a 25 as well. Look in product guide for the machines there was only one print system...

Yes the original detect switch seems to have fixed it. I haven't heard anything back since changing it.

As long as your only trying to print the print card is all you need. What Blackcat was referring to actually has to do with scanning you would need rtc as well. To upgrade firmware on print system...

This is the board the network cable plugs into. P/N D0135713. NVram clear ended up fixing machine and so of course since I opened it Ricoh wouldn't take back. Seems like had forever, make offer like...

Have Data Overwrite Security Unit Type H. EDP 414002. I believe it is for MPC5000 and MPC5501. Make offer, was opened but never used. craig@akcopy.net

Yes checked connector and it seems to know when df is closed and opened so I think those sensors are working. Going try switching around some sensors tomorrow see if can figure out what's going on.

I think it could but this one is intact as is the other one on other side on bottom that tells lid is down.

Yes that's the one I cleaned and as far as I can see as paper goes in it pushes arm into the original sensor which it is doing. The trail edge sensor is same as is couple the width sensors so will...

Wish we could find people with experience, were lucky get any resumes even when looking for no experience. I know you'll find work only be short time.

I did clean the original set sensor and tried checking in test mode but couldn't get it to register when moving arm. However not sure if this is result something else or just sensor being bad. Going...