All tray's is "set" on service mode isolation tab, I initialize the machine and update the FW to GDU-M1.
Type: Posts; User: PaperCut
All tray's is "set" on service mode isolation tab, I initialize the machine and update the FW to GDU-M1.
so far i check the all wiring and it goes to PCRB, so i order the board. Guys let me if there any software SW for this.
does everyone have seen this? I replaces MFB board, and SSD board, but still showing all tray unable.
C368 Costume paper size 12x12,
I have restaurant account that use a thick card 12x12 paper, is there any Engine FW Switch, for this? Or they can't use this kink of size.
It jamming, after a 1st...
Do you guys know where to get a Konica Minolta Polo Shirt with embroidery logo.
I'm looking for a polo shirt, Not button down shirt. Any website will do.
Same problem, J2002 on my C554e. I change every parts that 's parts manual say PS19, PS20, CL, Washer on the Cluth. Same problem. But after I see this bulletin pressure spring. I try it and so far it...
I'm having problem on one of my copier C284 when making a print or copy with 2 sided it jam. But when I do just a single side only, print or copy has no problem. It jam on paper exit section, so far...
I have a problem, w/ this Bizhub C200. I Can"t open the web browse on this. But I can able to ping the IP address, Scan to E-Mail, and Print. I connect my laptop to the copier, and still can't open...
I guess you can do a parallel port, But on 1 Computer ONLY. Try it to connect to your laptop, And your port is parallel port.
Corrupt firmware, failed memory or PWB-MFP board.
Reflash with current firmware. Or latest version firmware. Perform a Memory Test and replace Memory Module if needed. If the problem persists,...
Service EEPROM board (SVERB) has failed.
on the control panel , go to scan, settings, go to PDF, on the right side on the screen select MILT PDF
Clean the toner hopper, sensor, and check the gear too, On your developer check the gear if its turning.
konica 7085, Paper tray 3 will not unlock/open. Message display indicates "load paper in tray 3". Although unable to unlock tray 3, I am able to see paper in tray 3 drawer when tray 2 is open. (1st...
I have a C550 on a Lawer firm Account, that need a new Firmware. It have a scan to email account of 35, and Tracking account of 80.
How to back up all the account or HDD, fast, Easy and painless.
On the control panel, Check the right side of the panel if there a hole, and press it w/ a paper clip, it will reset the code, if not. It need a new fuser unit
try this
http://www.copytechnet.com/forums/konica-minolta/17676-hello-i-need-help-pls.html
I all ready have a relay board, amd motor. so I need FNS control board, and sensor
Thanks for your help.
I have a Di5510 w/ FS-110, can anyone help me with this services code 77-03.
Thanks.
Check your LINE VOLTAGE, A good reading should be between 110 and 120 volts
Remove the drum carriage and ensure that a binding condition does not exist. And Check the cleaning blade to ensure that it has not flipping. Apply setting powder to the drum and replace the cleaning...