Hi , Strange fault .I have a MX3071 that won't turn off with the power switch. As soon as the copier is plugged in it powers on no matter the position of the main on / off switch. Obviously i have...
Type: Posts; User: mabro1974
Hi , Strange fault .I have a MX3071 that won't turn off with the power switch. As soon as the copier is plugged in it powers on no matter the position of the main on / off switch. Obviously i have...
[QUOTE=skyfong;1961470]Dear guys,
Sounds to me like uptodate firmware and non original toner cartridge , maybe 3rd party compats. Latest firmware does that.
Hi is it ossible to reset the admin password on a MXM754 withouth going through Sharp.
We are currently refurbing a machine in the workshop with a changed password and the person who changed it has...
Thanks for the reply , i did clean everything 1st. Then followed instructions as per service manual. Why would dev units cause E7-11 when the fault is white shading error when the copy lamp is...
Hi just after some advice ,
I have had 2 MX2614's in the past couple of weeks with the same error code....E7-11 ( white shading error )
The error goes away after a reboot for maybe an hour then...
Hiya ,
After stripping down to refurb a MXDE14 on a MX2640 when the base is connected it says for trays 3 and 4 , please open tray and add paper , even when full. The trays do not lift up at all....
what error code is it
The mc board is what they call the HV board which has been swapped already.
Hi , just wondered if anyone had experienced this.
Error code C1-14 colour charge error.Also when the machine powers up and errors it leaves a thin film of yellow on the yellow drum.
All...
Thank you ,
But as the picture is a gif i cant read what it says its too small.
Where is the colour sensor located and the grey field. are they on the dev un its or is it the 2 sensors on the...
The density sensors on the dev units. And what's the grey field ??
I have a MX2610 which has really faint colour copies , prints and pcl test charts.
It has been fully serviced and calibrated with new drums , charges and devs, removed and cleaned laser slit glasses...
Got exact same problem on a 2640.
Tried emergency firmware and still the same. Gonna go back with a MFP board , memory and hard drive , sd card aand eprom
Hi there,
I have a mx2314 which is showing h3-02 code. I know this is high temperature issue. Nothing in the fuser at all and when code is cleared it just come straight back.
I have replaced...
made no difference but thanks anyway.
Looking like it needs new lsu
How do I do this.
tried it mate . still same
Yes mate it does,i actually put that in the description but thanks anyway.
Looking like a faulty LSU
Hi ,
I have a MX5112 which keeps coming up with E7-20 error.
It is running the latest firmware and only errors every 20-30 copies. When the code is reset it works again for around 30 copies...
yeah did that as soon as it was fitted.
Hi Guys wonder if anyone can help me, i have fitter a lc-11 lct to a mx5140 and when you try to select the tray on screen it just says tray 3 is ready to open...
I have had this a couple of times...
this is definetley magenta dev
We had the same fault on a MX4112 recently, it was a Surface Mounted fuse blown on the Mother PWB.
I replaced the board and resolved the issue.
Hi there ,
destination is set ok, where do i find " external telephone connection " within system settings
Hi guys i have a MX4112 and i have tried to fit a fax kit to it (MX-FX11) and when the machine powers up within a few minutes it throws up a F6-00 error.
I have checked all connections , reseated...