It sounds like you have all of the information necessary to set up their PC destinations. If you have a 420i series device in your office, you could set up the address book as if you were setting it...
Type: Posts; User: Metalvoc
It sounds like you have all of the information necessary to set up their PC destinations. If you have a 420i series device in your office, you could set up the address book as if you were setting it...
I am looking for firmware for a Panasonic DP-7240 (Toshiba E-Studio 720). If anyone has a way to get this to me, please let me know. Thanks!
no problem. you get into the maintenance mode the same on almost all Kyocera's. This one is no different.
That's pretty vague, but the big quality problem with these machines was coronas. The toner cartridge has a tendency to spew toner out the back, directly into the MC unit. Cleaning the grid and...
All good suggestions here. I have also had to disable V.34 on several machines. It does not seem to be as much of a problem as it used to be, but it does seem to be an issue when sending to some fax...
understood. Most techs with any amount of reasonable experience know to look for simple stuff like that, but from what I understand there have been a significant number of cases where this has...
When you install the PF-740, you have to install the "intermediate paper conveying unit". Check to see that this is installed correctly, and that the connector on it is fully seated. Also, ensure...
When you put paper in the feeder, the display says "Reset originals in the feeder"... is that correct? Does it say that even after you remove the paper from the adf tray, or only while you have...
Did it start immediately upon toner replacement, or soon after? Did you follow the entire toner replacement procedure? The aftermarket toners for these are terrible. If this is an aftermarket, and...
These things draw a lot of juice. If it is not a true 20amp circuit, it could cause problems. Also, I have seen people plugging things into the same circuit as a device like this, and when they are...
The drum and developer on these devices have a chip which contains the total count for these units. If I recall correctly, the only way to reset the count for the drum and developer is to replace the...
Are you up on your firmware? V.3 update included some measure to prevent "toner dusting". It made some change to the main charge values.
Thanks for the info. Is there a particular site you would recommend that will do a port scan?
Has the great advice you find here on this forum ever worked against you? Sure, I find wonderful solutions to all kinds of problems when I'm searching through these threads, but every once in a...
yes, thank you for clarifying. My point was that the fix does work, you just have to be patient.
I just had this problem with a 2560, and followed kkendric's advice, which he provided on another thread. I could also not move past the "program loading" screen. I had about given up on the fix, and...
Don't know that I've seen this before, but I would U906, re-load the firmware, perform your color registration and calibration, and give it another shot.
For clarification, these devices unfortunately do not support SSL. I have had mixed success connecting to different online mail services. When in doubt, I use our company's smtp to route the emails,...
The copies and prints are black? Have you attempted to print anything from the service mode with the same result? Could be that you need to replace the entire drum unit, but you should be able to...
Thanks Marc. I almost did this while I was there, but I was afraid of falling into Blackcat's situation, and end up spending hours getting it operational again, with the same end result. Maybe I'll...
Thanks guys! guess I should have looked a little harder
The fax drivers are still refusing to connect to this device. I have updated the main firmware, option firmware, U252 is set to the correct destination, fax drivers are the most current. I have tried...
What's the model of this machine?
I had a FS-4020 printer jamming on multi-size jobs (LTR & LGL). This was over a year ago, so I don't recall my thought process behind this, but my work order...
I have a customer that is getting this code now nearly daily. It is not in the manual, but I thought I had heard in the past that this was the "counterfeit" code. Though I may be thinking of a...
Neat! I'm gonna take a look at that when I get back to the office.I don't carry canned air myself. Like I tell my customers, don't blow dust out of you electronics unless you know where its going. I...