Heat roller was bad; replaced full fuser unit. TY Ron
Type: Posts; User: RonMac
Heat roller was bad; replaced full fuser unit. TY Ron
Ok thanks. Ron
Will try that. TY. Ron
Put new thermistors in; thermal fuses are good. TY for your suggestions. Ron
I am getting an error code 449. Replaced the thermistors, reset 08400 many times, but still get error code. Any help appreciated. TY
Ron
Got the 2300 up and running. No parts needed as reset worked. TY. Ron
Got the 2300 up and running, no fuser needed. Thank you. Ron
Got the 2300 up and running. Thank you. Ron
Got the 2300 up and running. Thank you. Ron
Ok will check that all out and thanks so much. Ron
I will check the above and get back with you. Heading back to the shop and taking a fuser with me, just in case. Ron
Ok I will try that and see how it goes...thanks so much. Ron
No it does not....any suggestions? Ron
Thank you...I did try that but it keeps going back. Some part must be faulty. Ron
Thanks, I tried that so the fuser or other part is faulty. Ron
How do you reset error code E000? Thanks. Ron
I am getting error code CF20 and E030 on the above copier. Any help would be appreciated.
Ron
Yes I am aware that 05-290 can mess up CQ. Thank you for reminding me. Ron
Thank you for the information. I will try that. Ron
Thank you I will try that. Thanks again, Ron
How do you clear the display message that reads Time for Periodic Maintenance? Thanks for any help.
Ron
Thought you might like to know I was able to clear all the codes and found the NV Ram Chip had a bent leg. It's up and running. Thank you again and enjoy the holidays. Ron
Thank you Ruben....I will try that tomorrow. Ron
How do I add, delete and change the user code on a Savin 9050 that I am working on in the shop. It is not connected to a computer and the previous owner does not have the user code. Can I use a...
Thank you so much...will try this.....appreciate this info...........Ron