The customer had approved the repalcement of the door, i had also cleaend and lubed the bushings on the orange roller in the fuser area, but the issues is still there, I have looked all over this...
Type: Posts; User: SMHtech
The customer had approved the repalcement of the door, i had also cleaend and lubed the bushings on the orange roller in the fuser area, but the issues is still there, I have looked all over this...
Thankyou for the replys, i will look into both of those options.
~Randy
I had replaced the registration clutch on this model and played with the adjutments of the reg. assy. until i was able to get it where it wasnt crasing or jamming on me for over 100+ pages. the next...
Thank you very much for the reply, i will give all that a shot and see how it turns out. i can hear the HDD spining and it isn't clunking accross the platters, so i hope the drive it good, and all...
From what i have read, i beleive i understand what most of everything is. I have this error on a customer machine and just happened. i checked the HDD physically, it is spinning fine and not...
sorry about that, typpe-o. it is a km-3530. with the C2000 service error.
I am getting mixed results on this when i google the error, some say its the main motor, others seem to feel its the scanner/laser assy. Not sure whats what. this error had appeared on this...
It turns out that the flag sensor shaft had broken in a spot that wasnt visable on the face down assy. when i moved the flag manualy, the fracture point had just enough drag to carry the flag through...
Hey everyone, i have a stubborn 5si here. PIU is new, fuser is new and all other rollers are good too. this printer jams everytime in spot only right as it exits the printer.it peeks out of the face...
Thank you very much ccs.
~Randy
Hello everyone, i have been trying to find a p# or even the correct description for the right door latch. Someone had mule kicked the door and shattered the nylon hook on the left side of the door. i...
Awesome, thankyou very much.
~Randy
Would anyone happen to have the above mentioned part numbers? I am new to canon, but have been a tech for printers and plotters for eight years now, this is just a new animal to me and any help would...
It just so happens that i have another canon here that when making copies, the image is loosing the top .5-.75". im not sure if this is the scanner, or the reg. assy? i had entered the service mode...
Hello Everyone. i have been working on this model with trying to figure out why this is jamming. the page feeds fine(new rollers) from tray and then just as it hits the reg, assy, it sounds almost as...