Did you see it on the machine or is the customer see the out of paper from their PC
Type: Posts; User: Mark B
Did you see it on the machine or is the customer see the out of paper from their PC
Run a belt pattern in main. mode 089. See what it looks like.
I have a 6520c with a CA20 code. Looking at the manual it looks like the laser could be the problem. Has anyone else delt with this code.
Thanks part of the problem was the transfer roller. The other part was to put in an old style fuser
First copy out has toner on back side of the page. It is comming from the fuser. The fuser is the new style, everything else looks good
I do not remember the code. The paper does not leave the drawer. I got a new set of tires and I took the feed and take up off of the collars turned them around and having one of my techs put them on...
I have a 6520c that is jamming from the tray with thick paper. I set the paper type to thick 1,2,and 3. still jamming. One thing that I noticed is that the tire tread is going the wrong direction. I...
It could be caused by a wire pluged into the wrong connector. Recheck the connectors.
This code still comes up intermittantly on this finisher.any ideas?
I have delt with this problem. You have to rebuilt the dev unit. There is a pm kit for the dev unit use it.
I think the kyocera 4800w is a kip machine. Does anyone know what the kip number it is?
Yes clean the idler roller shaft if it is not spining freely and also replace the roller under it, the diameter gets smaller in time.
Has anyone upgraded the firmware on a 3650w. How is it done?
Looks to me that the dv unit is not turning
Did you ever find out how to flash this machine? I need to flash one, but looking at the manual and bulletin #5, I am still not sure how it is done.
Now the big question. When and where is the training going to be?
How about the drum heater, ane the contacts clean, is it an oem drum?
The high end look the 820
It turned out to be the DPS. After it is replaced then you have to go in and reset the code, then go to 08-2561 turn it back on then run 05-396 and it will not error and the message is gone. The...
I can tell from your smart a** answer that you have never worked on a copier. All you do is sell manuals to end users and other untrained people, which takes money out of the pockets of people like...
Thanks but I have a manual.we replaced the yellow drum potential but the code is still there. How do you get rid of the code?
What does "service reccomended for SPC" mean
The belt for that drive is missing teeth. From the back of the machine it is on the right side and goes toward the middle.
The new fuser fixed it. It looks like it will be covered under warranty, but I still would have liked to know exactly what was wrong with it.
The c449 is an overheat code. That is what is weird that the machine comes to ready and making copies caauses the overheat condition. Yes it is on a 20 amp circuit. I actually pulled the machine and...