Hi there i have this message right after turning the machine on 5 seconds it shows it Copying and printing unavailable and also RAPs 03-482, 03-480,14-730,14-110, 09-060 a toad maybe is LVPS but...
Type: Posts; User: ivacopy
Hi there i have this message right after turning the machine on 5 seconds it shows it Copying and printing unavailable and also RAPs 03-482, 03-480,14-730,14-110, 09-060 a toad maybe is LVPS but...
Only change the all thermistors and you will solve the problem.
Hi
I changed developer + assy with another , there is no problem for now.
Thank you
Dali je sega dobre
Hi there
I have very small spots from magenta toner on the prints. Does anybody have idea what is the problem?
I tried couple of thinks: I replace the drum and IBT belt, but nothing has change
Try to reset the all memory
Change the toner motor
Dear Sir/Madame,
My name is Zlatko Spasovski and I`m from Macedonia,Europe.I`m writing this e-mail because I`m interested in for a job. I`m moving to USA at the end of May this year preciously in...
Hi
Check the toner hopper inside, you have to check does the toner licking or maybe don`t come out. If it`s ok you have to change the Toner Supply Rate.
Change the brown bushing on the pipe and yuo will fix the problem.
Clean the mag. rol. with alcohol I always fix the problem with this.
Did you change the developer, charge roller and drum?It might be the reason for the problem because the voltage always increases when the potential of the drum reduces.
- Press Clear Modes
- On the operation panel keypad, press 107.
- Hold down Clear/Stop for more than 3 seconds
- Then turn on and off
Sorry for my English
Yes for me could be a laser issue
Copy or print
After 2 days and many hours, I have changed many boards but at the end I found out that the problem was is new OPC drum (KATUN shit).
Thanks to all
Hi
After replacing a new developer, OPC drum and cleaning blade all over the paper I have developer. All voltage and settings are correct on the display. :(
Did you use tick paper 2 from the drivers
Hi
Yes you have to change the mixing roller or all developer unit.
Send scan jpg. picture from your copies .
Almost always is the cleaning unit (cleaning brash or seal under the cleaning brush)
Change the HDD with new
TRANSFER BELT is possible case
Print all four colours separation and see wich colour is problem
For me is problem with fusing unit