Problem Identified. Found a broken left door locking tab. Transfer roller not pressing well against the drum to drive paper through.
Type: Posts; User: cokwax
Problem Identified. Found a broken left door locking tab. Transfer roller not pressing well against the drum to drive paper through.
Scans Ok. Its a print issue. All A3 prints affected. A4 only trailing 1.5inch slightly affected.
Not sure how to describe this problem. Please see attached images. Affects mostly A3 prints and copies.40572405734057440575
Mine seems different issue. Safety bar switch is operating properly,Its switches click when pushed up and click again when released. Even its removal does not help.
Faulty Power supply caused a fault on my system PCB. Replaced both. Now getting an error at startup "controllare area presa carta" which I guess means check paper feed are. No paper is jammed, Papers...
I have to calibrate the touch screen (U201) every time I wake the machine from sleep. Sometimes even immediately after calibration, I have to do it again.
Buttons respond several centimeters away...
This error started being persistent on my GR3750 even after actually emptying the disposal box and setting it in place. I have tested continuity of the sensor wiring and all is well. I swapped the...
See attached image. This isn't a line as such, since it is not running down the page. I can call them random Toner marks.
It may appear anywhere on the page and the length varries. Some pages may...
Ok Thanks all.
A new Dev unit solved my problem.
Happens to both copies and prints. Internal prints using U089 equally faint. Changed Charger unit in vain. Transfer roller springs Ok.
I bought KM-5050 used. Produces faint copies from day 1 I received it.
Even at +3 density, the copies are still not satisfactory. Tried New Toner -same result.
Print head was the problem.
Wish u started with printer control board!
I have replaced 3 printer boards so far and a fourth one is now required.
The machine fails to complete image stabilization on start up and displays p-6, p-7, p-8, p-9.
When the printer board is...
Replaced Dev cylinder and primary Charging roller, problem gone.
I know someone else posted this sometime, but on my 3300 the problem is random. sometimes machine normal, other times zigzag copy. wondering what the problem is. Laser unit was never opened. I...
I have this same problem on my GR3750. When I disconnected all master sensors and tried again, the machine worked until the disposal box filled again and message persisted again. Could it be a sensor...
Machine indicates "Stabilizing image" and never comes to the Ready state. No error code indicated. Any ideas?
That is not TestPrint. It is a glass copy with the copyboard open, Cross-feed.
Test prints present the same result.
I wouldn't rush to a screw driver before trying with fingers first. i.e Attempt to clear the code first in service mode, then if it fails, take out the fixing unit.
See the attached Image of a 'would be' black page. I have cleaned and even changed the primary and transfer charging rollers, Replaced drum, Cleaned the dust-proof glass, Laser Scanner, done CCD...
To avoid getting done, I found a similar connector on my old scrap laserjet printer. I cut it off with sufficient wire to join to the GR wires. Thanks for your connector repair tutorial. I will now...
Thanks for your reply.
Actually, I realised the cause: The technician I had called to help me service the machine had put a new sensor which was not similar to the original. The sensors we kept on...
The sensing of the lower limit sensor has changed. The elevator paper feed tray now lowers when I close the light path of the the lower limit sensor. Once opened, the tray stops moving.
I have tried...
This is a sensor problem on my GR3750. The pressure control motor is running fine. The PRP led does not turn on and off when the light path is closed and opened. I tested with another working...