Search:

Type: Posts; User: walterman

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Re: Setting up MX-B201D with computer with windows 10 m=system not acknowleding print

    Scanning has to be done via Ethernet.
  2. Re: KYOCERA M6526cidn REPOST/Yellow TONER LITE STAYS ON

    Do you have an email address I can send it to? It's a 15 MB file.
  3. Replies
    4
    Views
    4,007

    [Jamming] Re: In Case You Get a PDPPD2_N Jam Code

    I think sometimes there are certain words that have been lost in translation in the service manuals. I can't think of any specific at the moment, but, I have run into my fair share of them. I think...
  4. [Jamming] Re: HP LaserJet 4250tn Jam in Tray 2 error code 13.01.00

    Is the lift motor engaging the paper tray fully?
  5. Re: Office jet Pro 8600 - Indicate jammed paper

    These printers are notorious for this error, most of the time there is nothing you can do. Google, hp 8600 class action lawsuit. These printers are basically throw aways.
  6. Re: New A-Series (306ci, 356ci, 406ci) - Thoughts?

    It would be interesting to have a 6 month review/ analysis on this post to see how these new A4 box's are performing.
  7. Replies
    5
    Views
    1,092

    Re: Sharp AR-M236, black lines

    Judging from your washed out image , I would suspect the copier is well beyond its 75k PM. I would look at the drum unit for wear spots along the edges, chances are that is where your black lines are...
  8. Re: New A-Series (306ci, 356ci, 406ci) - Thoughts?

    I have to be honest with you, I have never been a fan of Kyocera color, it seems their box's have more CQ issues than most. Now they are stepping in to the A4 realm, it rings the alarm bells for me,...
  9. Re: KYOCERA M6526cidn REPOST/Yellow TONER LITE STAYS ON

    I would be curious as to what resolves your issue. I have 12 M6526cdn currently in use, I do have an occasional issue on 1, where it is not adding the yellow toner properly and occasionally will give...
  10. Replies
    16
    Views
    2,988

    [Misc] Re: Sharp MX 7001N Color calabration

    Also, if the alignment of the colors are off, check the primary transfer belt drive gear for any cracks, as this will cause color alignment issues.
  11. Replies
    24
    Views
    2,754

    [Jamming] Re: AR-168 Document feeder jam

    Have you removed the spring clutches and cleaned out the gummed up factory grease and lightly relubed? These ADFs were notorious for jamming because of the grease hardening up in the spring...
  12. Replies
    4
    Views
    880

    Re: Rebuilding HP fusers

    Have you tried, TSA World Inc. or Metro fuser?
  13. Re: MX-FN11 stapler fires continuously, then jams up

    I used to have this problem on the old AR-F15 units, I used to replace flat cable staple connector assembly, that connected to the stapler pcb and the stapler motor, for the same issue. You could try...
  14. Replies
    5
    Views
    1,115

    Re: sharp mx-m550 jamming

    I have had this issue usually because of two reasons, the first, being cheap damp paper and the second being the ps assembly being worn out. It seems that if you clean the first set of grey rollers...
  15. Re: In need of a Canon IR ADV 4035 service manual

    I have received one.
  16. Replies
    10
    Views
    1,276

    Re: Toshiba estudio 203L HDD part #?

    Sriyanjan, that seemed to have resolved the error code, after reformatting the HDD, the MFP warmed up and made copies. Thank you, again for your help.
  17. Replies
    10
    Views
    1,276

    Re: Toshiba estudio 203L HDD part #?

    Thank you, I will give it a shot and let you know what the result is.
  18. Replies
    10
    Views
    1,276

    Re: Toshiba estudio 203L HDD part #?

    Yes, I am able to access service modes.
  19. Replies
    10
    Views
    1,276

    Re: Toshiba estudio 203L HDD part #?

    Thank you, I appreciate the quick response. I have access to the firmware, however in the srvice manual it says that there is a download jig I may need. I also see that there is a way to download it...
  20. Replies
    10
    Views
    1,276

    Toshiba estudio 203L HDD part #?

    I am currently working on a Toshiba estudio 203L, that has a F103 error code, according to the service manual, I will need to replace the HDD. I could not locate a part# for the HDD in the parts...
  21. In need of a Canon IR ADV 4035 service manual

    I'm in need of a Canon IR ADV 4035 service manual. Thank you in advance.
  22. Replies
    1
    Views
    1,910

    Re: Canon CR-180 issue

    I tried reloading the system software, checked all power connectors, still the same issue. I had the customer buy a new one.
  23. Replies
    1
    Views
    1,910

    Canon CR-180 issue

    I received a call for double feeding, I replaced the feed and sep rollers (mf1-4210-00, mg1-3330-000). The issue I'm having now is it pulls the checks trough, however, the checks will stop randomly,...
  24. Replies
    7
    Views
    1,467

    Re: Sharp AR-M550U

    Bad HDD.
  25. Replies
    6
    Views
    1,534

    Re: MX-4100N hanging

    I appreciate, all, for your input, I actually just started ( this week) dealing with a similar issues on the above mentioned MFP's (both), strange as it may be, and it helps me out too, thank you,...
Results 1 to 25 of 197
Page 1 of 8 1 2 3 4