Search:

The End Of The Day With Ray! Konica Minolta Employee Reduction! Are They Collapsing All Covered? (youtube.com)

Used new rollers for many years. Also on C3350i devices. Have to cut off the lock on the blue roll.

Setting up the printer | Lexmark CX920

C258 series?

There have been cases where security printing is enabled and the network speed is 100, the scans did not go through.
Speed changed 1gb.

System2>image stabilization setting>color priority. maybe make adjustments more often??

Yes it is.

It's a shame that Konica prevents the use of used drums. It would be good if you could reset the drum counter in the same way as the toner bottles, belts and fusing units.

This is exactly what it was all about. New drums from the transport-damaged device and the picture is bad. And before this the device was mute and had to change the cpu assy

Cut 2-4 turns of the spring.

The customer reported that first a bad picture, then an error code E002
And the printer didn't turn on anymore

First E002 & new cpu board & everything OK..But print image is bad. Black print is OK.

58415

PH unit?? Memory board changed & tar reset done.

Drums & belt OK

Symptome
Abnormal high toner consumption and IU’s do not last the specified lifetime.

Cause
The paddle part of the spiral beat screw shaft is not wide enough to remove the remaining developer...

a lot of small white spots

Developer unit broken. I would also change the drum. Black developer unit cheaper than drum

if you rotate the waste toner container on the wheel, then the white part should move in the opening of the waste toner container.
If not, the waste container is broken

To improve the quality of the waste toner box used in the Sparrow series

1) If the waste toner box is dropped from a height exceeding 30 cm (out of specification),
the impact of the drop...

auto paper type detection is option C250i-C360i
Standard >>C450i-C750i
Admin can disable this & choose which cassettes are in use.

& MK-602

No part has lasted as promised....

Agree

You can find it there....

Change >>Ejector Unit

Products: bizhub C250i;bizhub C300i;bizhub C360i

These trouble code C-2551 C-2553 C-2555 C-2557 can appears randomly. Sometime without action the TCR level recover by
itself a good level but...

The paddle part of the spiral beat screw shaft is not wide enough to remove the remaining developer at the paddle parts right above the TCR sensor

The comb type paddle will be changed to one...

10 minute job.

KM INFO>>The cause is related to dry shafts on Exit Idle Rollers and unlubricated contact points on Exit Roller Assy.

One fault C7633 was where I had to change>>Power Source Unit (Bizhub C750i)