Usually you can just install the fax. It does not require a maintenance mode to work correctly. u600 usually pertains to resetting the fax unit to factory defaults if something was not working...
Type: Posts; User: eholyst
Usually you can just install the fax. It does not require a maintenance mode to work correctly. u600 usually pertains to resetting the fax unit to factory defaults if something was not working...
Looking in other service manuals for the larger machines I see that it references
"Abnormality detecting in an image-processing part"
with the following suggestions
1. Check contact of a DDR...
Checked on both of those suggestions. Toner was correct and the front cover switch was working normally it just never clears the error. Customer was not really worried about it and just said they...
Has anyone seen an issue with the hp p2035 where after you replace the toner the message to close the front cover keeps displaying? Have a customer who purchased a cheap one and I took a quick look...
We have a sub contractor that took a look at a P6035cdn and said that the machine functions fine for PQ and out of the cassette but any prints from the MP tray are skewed. The paper is pulled fine...
@lebo- Fuser units check out fine no paper in connector.
I tried a couple different things. Swapped the machine with another that is in the same office error followed original machine. Put a high...
@neomatrix- It could be a power issue in the building that I am unsure of and we would need permission from their corporate office to do any testing with that. No industrial equip in the building...
There are a few 2000's in locations that have been giving us 6000 codes. Normally we just replace the fuser test and be on our way. Recently though we had replaced the fuser with a brand new unit...
@tecchie- If this machine is only a year old you should either be able to get the board replaced under warranty or at least get a repair board which should be half the cost of the new board you...
Hi I am looking for the fax keyboard cutout that goes on the operation panel. If anyone has an extra please let me know thank you.
So far we have 2 machines with it. One of them was a 2026c mfp. We already repalced the scan unit and by this time the customer was a pita so we did it as a preventative measure. We had another one...
I have attached a QA report on this issue as it affects alot of models.
Possibly bad toner? Have you tried swapping a known good dev with one of the trouble ones?
You could try turning off ecm. I have had that on alot of machines as well.
I resolved the problem by replacing the scanner unit. Tested afterwards no lines on copies or scans. Before I replaced it though our rep had come in and told us about the black strips they had been...
The only thing is that when the lines appear if i put in the same page for copy or scanning the lines stay exactly the same.place. If I change the page being copied the lines move. Same thing happens...
I have done a firmware update and checked and cleaned the glass. The flatbed scanner works fine no lines. I did a 1087 report and ran it through the DF. The lines were no consistent and seemed to...
@blackcat4866-Just changed the fusing temp. It has no discernible effect though. They are using the envelope pressure setting for them. I tried changing the setting to other types still had no real...
Yes it is in envelope mode. With the optional envelope feeder attached you don't have another choice. I unfortunatly have not had the luxary of seeing them print "good" envelopes from their location....
Get a call that they're specialty envelopes are having the toner rub off up until that point it was working for quite some time. We go replace the fuser same issue. This is with the optional envelope...