Thanks the mc i was at was only a month old and as for noise no idea what they mean.
Type: Posts; User: andyt2107
Thanks the mc i was at was only a month old and as for noise no idea what they mean.
Thanks for the pointers turned out to be the fuser motor so oiled it up ran the tests all good.:o
Hi all been a while i am going to one of the above which is making a chirping noise intermittently maybe once a day anybody had this and know a fix will run the motor tests when i go.
Yes like the others say i have replaced a few of these.
I have a very low opinion of any Samsung copiers since working on them they have upgraded the look of the mc but they have a lot of problems never sorted like misreporting toner levels mc error or...
I agree our company use them tends to happen when they don't fit drum seals properly false economy in my view.
Like the others say I would look at the Fuser happens on other HP's I have worked on.
Hi what are the error codes do you have access to the manual if it is a new finisher then I would expect it to work unless there is a problem with the mc itself.
The problem turned out to be the staple unit not returning to the home position so we replaced the whole staple assy and module.
Thanks for the replies turned out to be staple unit in the end fixed at last but cost money.
This is driving me nuts the finisher ejector assy was jammed and had a message of output bin 1 out of service error 11-902 but not in manual. Replaced ejector assy but message still there so rang...
Its okay When i removed the printhead found wax all over the bottom of it so have order a new rather expensive one.
Hi all
I am having problems with one of these which is leaking wax into the mc i have replaced the inkloader about 3 months ago have been back for this issue cleaned all out and the mc was working...
I have a copier that has PPD2 errors from all trays i have replaced the sensor which worked for about a week i tested the sensor which was working anybody else know a fix or do i put a new paper feed...
have you looked at the sliver wire contact behind the gear of the transfer roller is it bent over and not making contact?
i was wondering if anybody has had issues with slow scanning on this model going to a customers with this problem.
Cheers in advance
yep only way to go
I have had the same problem with generic cartridges another thing to look at is the transfer belt if the mc is over 100000 prints would need new one hope this helps.