Search:

mpc5000 D0296318 and D0296319 mpc4501 is the same you will find the part under main frame

I had this on a 201 I took the whole controller box off and turn the machine on and the display panel came on with a sc code it was a bad controller board.

I had this it sounds like a cat scratching I thought it was the fuser but it was the anti static brush on the transfer roller the metal spike stick out scratching the paper.

Is this on the ITB or the transfer roller side?

once you get to service modes do SP 2928 thats the toner end clear.

Try this part # D1494750 Bracket motor Duplex

I had this on a MPC2550 I went to user tools then scanner and in there is a shut off for the print the Scan Log.

Thanks guys appreciate the info.

Hey turbojetboy have you put in any of these new MPC6502 MPC5100 if you have how are they performing? any better than the junk MPC6501.

Its not compatible.

this is my go to bag SwissGear Patriot Wheeled 2-Piece 17" Laptop CaseError

The help desk for service Tech. went to Atlanta all the guys that helped the techs did not go to Alanta and the one who keeped gooses is gone.

The guy who keep and updated the gooses guild is gone laid off with the rest of the NJ. help desk. It most likely will never be updated again what a shame. Ricoh is going down hill very fast. I am an...

Should't you be using developer type 24?

I have a few of these doing this now .I will post if I find something

Go to scanner sp 1015 it is set to 1 make it 0 that will get rid of the time stamp

X 2 on the registration mylars

I get that all the time change the inverter sensor GW010007

17421 I know its a 6002 but check this tsb out anyway I had this 06 jam and this worked

I'm having the same problem 2 new machines. If I find something i will post .....

mismatched controller PCB make sure of correct part # for model #.

The MPC6501 is the BIGGEST piece of shit don't even think of getting one

NCR paper
I have an 1107ex that is running large amounts of 11x17 Appleton ncr paper. It is double feeding quite frequently. We also ran an 81/2x14 job and after around 500 it started to do the same...

finisher exit

X2 for the drum drive pulley