Dont have account with Ricoh...!
Type: Posts; User: bernardo749
Dont have account with Ricoh...!
Amigos,
Me podrian por favor orientar para realizar la actualización del fimware de los equipos Ricoh de la serie Aficio MP y donde podria descargar los ultimos firmware...
Los modelos que...
The error is causing the power supply, I'll replace it with a new one!
Friends! What causes the error is a gear to DC Shutter (B223-1213) ... Damaged gear blocks the mechanism shutter. I'll buy a new one to replace it. Thanks to all!
Friends! What causes the error is a gear to DC Shutter (B223-1213) ... Damaged gear blocks the mechanism shutter. I'll buy a new one to replace it. Thanks to all!
Friends, thank you very much for your advice and your help! I will review the shutter motor to see if it is damaged and repair it! Informs to you!
Ok ... the 002 check was on 09 set in 38! But continuous error! :(:confused:
Thanks,But continues to show the error!
I removed the metal plate you see in the picture! Keeps throwing error! Friends, will have other suggestions? Thank you again!
...
I removed the metal plate you see in the picture! Keeps throwing error! Thank you very much for your help!
30778
Friends, will have by chance a picture assembly sutter please? Not the manual parties to reach me best!
Place the shutter assembly! It is difficult to remove? Will have at hand the steps to do? I'm tired of looking for technical and would not solve the problem. You have helped me with their advice,...
This code does not appear in the service mode. Only the following codes in 2914:
001 open delay time, delay time close 002, 003 Sutter open, 004 Sutter close
I think I am confused when you mean shutter, in this case would be the engine? You will have a referential image shutter please!
I think I am confused when you mean shutter! The shutter for me...
Estimados,
La presente es para por favor solicitarles su apoyo y ayuda.
Tengo una fotocopiadora Ricoh Aficio MPC 4500 con el error SC 290, segui varios post en el foro referente al error y...
Muchisimas gracias amigos...!
Envie la unidad fusora a otra ciudad, para hacer una prueba con un equipo similar y luego enviare la fuente de poder. Estare informando para ustedes!
Saludos!
Dear, I appreciate the help and advice of all! I just want your opinion taking into account their experience with this equipment. Not to make a hasty purchase BiCU card. So I discussed the problem is...
Recently the company had problems with electricity. the power supply was damaged and was repaired, it worked properly for a month and then began to give the SC542 error, do what you said before and...
Locate thermostats! I was told that launched the ground, but still gives the SC542 error. Not how to test whether termostatatos are working properly.Commented tests:
-The Continuity of the lamp...
Results:
Roller Center: 27 deg
Roller Ends 27 deg
Machine Inside at Power: 26 deg
Machine Inside: 29 deg
Where they are located these thermostats?
It is possible that this confused! I send you a picture of what I think are the thermistor! The fuser unit is heating properly. Similarly could you please tell me how to check the temperature as...
Greetings to all! I have a Ricoh Aficio MP 4001. With the SC542 error, do the tests thermistors and fusion lamp, both work correctly. Similarly change thermistors new ones and make the fault reset...
In the end I had to send to an authorized Canon photocopier in the capital center of the country. I hope for your repair.
How could prove that these connectors are working?
Where is located the DCON? What is your part number?